Mounting Hardware 6mm
Description
There are 4 styles of eyelet hardware for FOX shocks: 2-piece reducer, 5-piece flanged bushing, Bearing Mounting Hardware and 7pce crush washer eyelet hardware.
- The two piece reducer hardware assembly is made up of two reducers, pressed into either side of a DU bushing (sold seperately) that is pressed into the shock eyelet.
- The 5-piece flanged bushing eyelet hardware assembly (being phased out) is made up of two beige colored flanged bushings that are pressed into the shock eyelet. A hollow pin is pushed through the flanged bushings and centered by black Delrin spacers on either side of the eyelet. Thin o-rings go between the spacers and flanged bushings to prevent contamination and premature bushing wear.
- The Bearing Mounting Hardware assembly is made up of two black Bearing Housings that are pressed into the shock eyelet. Two Roller Bearings are pressed into the Bearing Housings with a silver Bearing Spacer trapped between the two Bearings. Black Bearing Spacers go on the outside of the Bearings to center the assembly and prevent contamination.
- You will need the Mounting Hardware Bearing Assembly Install and Removal tool (PN: 803-01-406) to remove this style hardware once installed.
- The new for 2021 7-piece Crush Washer eyelet hardware assembly is made up of two polymer (beige coloured) flanged bushings that are pressed into the shock eyelet. A hollow pin is pushed through the flanged bushings and centered by black Delrin spacers and Crush Washers on either side of the eyelet. Thin o-rings go between the spacers and flanged bushings to prevent contamination and premature bushing wear. The Crush Washers have raised domed portions that are depressed before installation and take up any play found between frame and hardware